Unbrick, cứu boot Samsung SGH-T959V ok log repair Mã: Open serial port...OK Connecting to the RIFF Box...OK Firmware Version: 1.37, JTAG Manager Version: 1.56 Selected Resurrector: [Samsung T959V V1.00] Connecting to the dead body...OK Detected dead body ID: 0x1BA00477 - CORRECT! Set I/O Voltage reads as 2.79V, TCK Frequency is 8 MHz Resurrection sequence started. Establish communication with the phone...OK Initializing internal hardware configuration...OK Uploading resurrector data into memory...OK Starting communication with resurrector...OK Detected an Initialized FLASH1 Chip, ID: 0x00EC/0x0060 (1024MB) Selected Resurrection Data for the NAND Chip with Page size = 4KB Flashing the dead body...OK Resurrection complete! log flash rom Mã: <ID:0/047> Added!! <OSM> Enter CS for MD5.. <OSM> Check MD5.. Do not unplug the cable.. <OSM> Please wait.. <OSM> T959VUVKC1-REV00-ALL-low-CL933594.tar.md5 is valid. <OSM> T959VUVKC1-Phone-CL932707.tar.md5 is valid. <OSM> SGH-T959V-CSC-TMB.tar.md5 is valid. <OSM> Checking MD5 finished Sucessfully.. <OSM> Leave CS.. <ID:0/047> Odin v.3 engine (ID:47).. <ID:0/047> File analysis.. <ID:0/047> SetupConnection.. <ID:0/047> Initialzation.. <ID:0/047> Set PIT file.. <ID:0/047> DO NOT TURN OFF TARGET!! <ID:0/047> Get PIT for mapping.. <ID:0/047> Firmware update start.. <ID:0/047> zImage <ID:0/047> boot.bin <ID:0/047> Sbl.bin <ID:0/047> param.lfs <ID:0/047> factoryfs.rfs <ID:0/047> cache.rfs <ID:0/047> data.rfs <ID:0/047> modem.bin <ID:0/047> Transmission Complete.. <ID:0/047> Now Writing.. Please wait about 2 minutes <ID:0/047> Receive Response form LOKE <ID:0/047> cache.rfs <ID:0/047> data.rfs <ID:0/047> RQT_CLOSE !! <ID:0/047> RES OK !! <ID:0/047> Completed.. <OSM> All threads completed. (succeed 1 / failed 0) <ID:0/047> Removed!!